Can someone explain the guide for cura 2.6.1, to use it with the Delta-Go-Upgrade

Discussion in 'Software' started by Greed835, Sep 20, 2017.

  1. Greed835

    Greed835 Member

    Joined:
    Dec 1, 2015
    Messages:
    46
    Likes Received:
    40
    Can someone explain the guide for cura 2.6.1, to use it with the Delta-Go-Upgrade. There is no information on how to send the Gcode commands through the latest cura, and to control the printer like i am use to through the pronterface window. I followed the guide, but there is no information @Shai.
     
  2. Shai

    Shai Master printer guru Deltaprintr Staff

    Joined:
    Dec 25, 2013
    Messages:
    1,305
    Likes Received:
    287
    The new Cura 2 does not support USB printing yet. You will need to save the gcode to the MicroSD card and run it from there.
     
  3. Mike Harmon

    Mike Harmon Active Member

    Joined:
    Sep 18, 2016
    Messages:
    228
    Likes Received:
    29
    Any idea how close they are to implementing it? Wondering if I should start down the octopi road if it looks way off in the distance.
     
Loading...

Share This Page