Faster auto-level?

Discussion in 'Software' started by OneTwo, Sep 25, 2017.

  1. OneTwo

    OneTwo New Member

    Joined:
    Dec 29, 2015
    Messages:
    8
    Likes Received:
    5
    Been having this machine for a couple of years now, and I must say the worst part about it is the auto leveling. EASILY 50% of the time the auto level will fail because the hotend moving will cause enough vibration to set off the FSR.

    Is there any way to simply have a center one touch level? There is absolutely n0 reason to have to test in 16 different areas every.single.time.
     
  2. Shai

    Shai Master printer guru Deltaprintr Staff

    Joined:
    Dec 25, 2013
    Messages:
    1,321
    Likes Received:
    291
    Sounds like this is about the older laser-cut wooden printer, not the Delta Go printer.

    The reason for testing multiple points is because the acrylic bed tends to warp over time. If you were to only probe one point in the middle of the bed, that would detect the height and nothing else. Do you have the pads on top of the FSR sensors to alleviate pressure?
     
Loading...

Share This Page