Our recommended thing to print to test your printer.

Discussion in 'Things' started by Shai, Oct 28, 2015.

  1. Shai

    Shai Master printer guru Deltaprintr Staff

    Joined:
    Dec 25, 2013
    Messages:
    1,305
    Likes Received:
    287
    We've updated the support page to reference this. After searching for a while to see what the best object was to print in order to test your print settings and printer's resolution, we've settled on http://www.3dbenchy.com/

    They have a variety of great tutorials that walk you through troubleshooting your print and adjusting settings. Definitely check it out and give it a try!
     
  2. RoBoMono3D

    RoBoMono3D New Member

    Joined:
    Jul 31, 2016
    Messages:
    18
    Likes Received:
    0
    I like that too, I print it on my printers, but just a calibration circle, or cube works to, and the make torture test really works too.
     
  3. denys

    denys Active Member

    Joined:
    Apr 20, 2014
    Messages:
    659
    Likes Received:
    176
    I like this little friend:) So far I've printed quite a few and given them away. They have proved very popular indeed.
    It is not my design, well above my abilities, but I modified it to add a 6mm magnet so you can use it as a fridge magnet.
    http://www.thingiverse.com/thing:1862194
    It is printed with no support or brim. If your printer is running well a very clean print results.
     
Loading...

Share This Page