Some maintenance required....

Discussion in 'General' started by denys, Feb 15, 2017.

  1. denys

    denys Active Member

    Joined:
    Apr 20, 2014
    Messages:
    659
    Likes Received:
    176
    This is probably an obvious post, but I was having intermittent feed problems so using a pin, I cleaned the built up plastic out of the grooves on the extruder drive pulley. It works much better now :)
     
  2. Kaare

    Kaare New Member

    Joined:
    Nov 12, 2017
    Messages:
    12
    Likes Received:
    2
    Thanks for the tip.
     

Share This Page