TPU?!?!

Discussion in 'General' started by bubbasanjohn, Nov 1, 2017.

  1. bubbasanjohn

    bubbasanjohn New Member

    Joined:
    Nov 1, 2017
    Messages:
    4
    Likes Received:
    0
    Hi Y'all, trying to print TPU and not having any luck. Filament just bunches up on the brass wheel. Anyone doing this successfully?

    Would appreciate any tips. Kinda feel defeated as the web site says this printer will print ANY material. Well not out of the box and the specs for the filament.
     
  2. Kaare

    Kaare New Member

    Joined:
    Nov 12, 2017
    Messages:
    12
    Likes Received:
    2
    Is your filament 1.75mm? I haven't tried any flexible filament yet. Try the live chat thing on the web site. They're very helpful.
     
  3. Shai

    Shai Master printer guru Deltaprintr Staff

    Joined:
    Dec 25, 2013
    Messages:
    1,305
    Likes Received:
    287
    You can definitely print semi-flexible filament. If it's fully flexible, you may get away with it by printing it slowly. This goes for any printer as flexible filament likes to buckle up easily.
     

Share This Page